Ham projects for 2025

 2025 has dawned with a fresh list of aspirations for myself.  While some goals, such as a new job, are outside the scope of this blog, there are multiple items that deserve to be listed here, mostly to hold my feet to the fire.

Site Summit BBS:

 I've managed to convince holdouts on the KL7AA board to let me move forward with an upgrade/replacement of the packet node on Site Summit.  The plan is to install a full featured linBPQ based packet node with BBS, forwarding, and Winlink capabilities in its place.  There will be a 1200bd port on 145.010MHz and a 9600bd port on 440.050MHz.  Ideally, this will also be links to the Wasilla node too, although I haven't yet approached the MatSu club on this matter.

Robust Packet HF APRS igate:

 The radio running the Robust Packet HF igate on 10.1473MHz USB has apparently seem to have gone deaf, although I have not dedicated time to in-depth troubleshooting of the system.  For the time being, the igate has been pulled offline, pending future troubleshooting efforts.  The future of this system is, at this time, unknown.

Home shack master plan:

Utilizing my current Hermes Lite 2 and shack pc running Linux Mint, plus hopefully a Hardrock50 amp if I manage to save up the money, my purely personal goal is to have a fully remote HF operating position.  I also plan to bring my VHF igate back online.  I also have a SEA-222 marine HF transceiver, which, if it is stable enough, I plan to press into service as an HF packet node on 14.105MHz LSB (technically 14.102MHz USB, since packet doesn't care, but who's counting).  If all this jank actually ends up working, I may crosslink the HF packet and VHF APRS port, but that's much further down the line.

There's a lot up there, when you start dissecting each piece, and that's before you factor in other obligations, but I think I can pull it off.

~moose

Milestones

 Fiber is pulled all the way through the conduit, into the garage and house.  Confirmed as good end to end with equipment connected on both ends.  Next step is to get radios and hamputer relocated, everything on a UPS, vlans set up, etc etc.  The important takeaway though is I now have a working layer 1 between house and garage!

~shotgun moose

Shotgun Moose goes off half-cocked

 Somewhat expensive lesson to learn, but learn it I did. Always pull cables by their jacket, not their termination.

Internet out to garageshack will (eventually) be provided by a fiber run.  I had purchased a pre-terminated length of fiber with LC connectors on each end.  Off I go, eager to get operational, and I make the mistake of tying pull line to just the LC connector, and not the cable jacket too.

Half way though, the pull line gets really light, and all that comes out the other end is the LC housing, sans any fiber.

Don't be like me! Learn from my mistake!

~shotgun moose